WICKS MISSION STATEMENT
At Wicks we are committed to
providing exceptional, fast and
friendly service. By supplying
and supporting a broad range
of products and materials,our
mission is to help you complete
your next project on schedule
and with quality parts and
Neoprene and silicone impregnated wire coil supported fiberglass aircraft
ducting meets applicable FAA and military specifications. Neoprene ducting
is stocked in 10 foot lengths. Silicone ducting is stocked in 11 foot
lengths. Odorless and nontoxic ducting is important in heat and vent systems.
Aeroduct neoprene and silicone ducts have been fully tested by civilian,
commercial and military aircraft manufacturers and approved. Buna
(“nitrile”) types have odor at elevated temperatures. CAT - 1 ply neoprene impregnated fiberglass with very closely spaced spiral
copper coated high carbon steel wire inside exterior wrapped fiberglass
cord. From -85 degrees F to over 350 degrees F. Aircraft type. Maximum
length 10 feet. ...
This unit is designed to slide over the
end of the 2” O.D. tube protruding
from a cabin heat box that extends
through the firewall. The short end of
this unit is expanded to 2” I.D.
One stainless steel clamp is furnished
with the unit. If you use
scat tube the 90° angle allows
you to run the scat tube parallel to
the firewall and away from undesirable
areas (brake pedals, etc). Constructed of
seamless 6061T4 .028 wall tube. Weight is 1.4
The specially treated polyurethane element in the Bracket filter assures near total protection from any foreign
material entering the system. Repels water fire retardant and has good air flow for proper fuel/air ratio. Has no pleats to collect dirt. Low-cost maintenance
with increased engine life. FAA approved
Universal sized K & N air
filters for use with Rotax
filters are specially designed
to combine superior
airflow with up to
99% filtration efficiency, resulting in increased
engine performance. Pliable rubber flanges absorb
vibration & may be stretched up to 1/16" for
in-between sizes. Filters may be cleaned, reoiled,
& re-installed up to 25 times using K & N
air filter oil & cleaner. Chrome finish cap.
'SP'models have a rubber cap & include tabs for
safety wire securement.
Re-usable, long-life Challenger
air filters are designed
to give up to a 50%
increase in airflow performance
over other filter
brands. This typically translates
into a 2-4% increase in
horsepower as well as increased
fuel economy. Installation requires no
modifications (they are direct filter replacements).
Filters require cleaning & oiling every 100 hours;
cleaning operations may be repeated up to 25
times before filters must be replaced. FAA-PMA
approved. CPE1957 requires 990704 Sealing
Grease for installation.
Universal sized K & N air filters
for use with Rotax engines.
These filters are
specially designed to
combine superior airflow
with up to 99%
resulting in increased
engine performance. Pliable
rubber flanges absorb vibration & may be
stretched up to 1/16" for in-between sizes. Filters
may be cleaned, re-oiled, & re-installed up to 25
times using K & N air filter oil & cleaner. Chrome
finish cap. Choose correct part# by size & style.
K & N filters must be oiled for maximum
performance. K & N oil uses a mineral
oil base blended with special
polymers to form an efficient
tack barrier for superior dirt
particle filtration, while at the
same time permitting maximum
airflow. Available in
aerosol or squeeze bottle.
ORM-D - Ground Only.
Wicks Aircraft and Motorsports | 410 Pine Street Highland, IL
62249 Orders: 1-800-221-9425 | Help Line: 618-654-7447 | Email Us Toll-Free Fax: 888-440-5727
Policy | Site